Along with the screws in the curtain rod package it also came with white plastic screws though they were not sharp but not sure what they are for.
Curtain rod won t stay in wall.
Clever brackets exist that allow you to mount a curtain rod directly to the corners of the wood molding around your window instead of in the wall.
Get some small screws or nails again you can ask at the hardware.
Drywall may look solid enough but it won t hold a screw and if you mount a curtain rod improperly you ll end up with a sagging curtain and a hole to patch.
Install it by marking both ends at the correct position on the wall directly above the base of the shower and tub then compress the rod and position the two ends in place before releasing.
After a while i figured the springs must have been wearing out so i purchased a new tension rod.
It stays in place thanks to twisting tension but don t worry it won t damage your walls.
The next best option is probably to use a toggle bolt anchor.
This one stayed up for about a day and now it won t stay put for longer than a couple of minutes.
The best way to mount anything on.
The lining material won t damage the wall and is easy to trim to the contours of the caps with scissors.
Both ends of the rod must meet at precise right angle to the wall horizontally and vertically.
The best thing to do is avoid drywall anchors and screw directly into a stud.
You ll have to patch up these holes which may be a bit of a pain to do with the textured walls but it s doable.
If there s one close enough that it looks okay you should do that.
You don t need any tools to install this shower curtain rod.
Tightening the tension rod enough to compress the liner should make the rod secure enough.
In the wall surrounding the window are 2x4 studs of solid wood the window frame is put into the stud frame when it s installed.
Instant curtain rod holders wrap around the top corners of your window molding.
The walls are tile and it s a rental so i can t drill into them.
Every few days the tension rod holding my shower curtain up was falling down.
A small v shaped piece slides behind the molding to secure the holder in place.