Setting up circular saw.
Cutting large plywood sheets.
In this video i m cutting a full sheet in half which will be.
In order to cut down plywood it needs to be set up on something like a.
For circular saws grab a 15 20 carbide tip blade designed for plywood.
Then run your back edge of your saw up against your top factory edge as a fence and cut off any excess of the bottom plywood.
You only have to clamp the ends.
The large size and the weight of plywood also makes it difficult to cut a full sheet directly on the table saw.
The most common size for plywood sheets is 4 x 8 feet followed by 5 x 5 feet.
When ripping a large sheet of plywood image 1 on a table saw use an outfeed table image 2 or roller stand to support the board as it comes off the saw.
Now you can lay your cut line on the new piece of plywood you want to cut right on the cut line and clamp it.
For table and miter saws invest in an 80 tpi plywood blade one designed for cross miter saw or rip table saw cuts.
When cutting a sheet of plywood it s important that you support the sheet on both sides of the cut.
Cutting full sheets of plywood was always a challenge when i didn t have an extra set of hands.
Put the best edge of the wood against the fence and push the corner of the board into the fence to keep the board tight against the fence throughout the cut image 3.
The tricky part is clamping it in the right spot for an exact cut.
Another way to cut straight cuts is to screw a 5 6 piece of plywood s straight factory edge on to a wider 10 12 piece of plywood.
The most convenient way to do is is to procure a 1 1 2 inch thick installation about the same size as yours sheet and play it on the floor.
The easiest way to cut down plywood sheets step 1.
Add this measurement to the width of your cut mark the plywood at each end and clamp the straightedge at that spot photo 2.
The alternative is to cut it into small size using a circular saw.
These project panels help eliminate waste cut costs and are easier to transport than full size panels.
Eliminating the need to remeasure.
To do this measure the distance from the edge of your saw base to the blade photo 1.
If you re cutting a sheet of plywood that is 75 inches 1 9 cm thick set your blade to 1 inch 2 5 cm deep.
3 support the whole piece of wood.
We also carry pre cut project panels that are available in different sizes that may vary by store.
