This will lock each segment along the suspension wire.
Diy gutter planter.
The front and back of each gutter piece will have 2 holes.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
Tie a knot at one end of the 10 foot rope.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.
Garden answer youtube.
Repeat threading up through the bottom hole and out through the side hole on the next two left gutter sections.
10 ft vinyl gutter but i only used about 6 feet of it 3 sets vinyl gutter end caps 1 4 inch natural fiber rope it comes in 50 feet rolls which is plenty home depot pdf instructions.
Start by drilling the bottom holes using your drill and 3 8inch bit.
For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment.